Heavy Duty Toe Alignment Tool Plates with Tape Measures, Upgrade Stainless Steel Wheel Alignment Tool Plate with Hanging Holes for Easy Wall-Mounted Storage, Silver

As much as it pains me to endorse what I suspect is ultimately a copy of BleepinJeep's idea, this is a great product. The slots for the tapes are a nice touch. But especially, it is cut to clear big brakes on a JK. (Or it at least cleared my JLUR HD calipers just fine while level.) It doesn't make sense to spend money on an alignment for something like a Jeep where there isn't much to align and setting the toe and wheel with this only takes a few minutes. These--and the products like them--are very easy to use and extremely accurate. Don't count on the instructions being sufficient. If you need instructions, this might not be for you. Or at least check out some YouTube videos. I wouldn't mine a set that are longer still. It would make it easier to get aligned to get the wheel straight. And some tire plates that would clear 35s for quicker and dirtier work.

had obvious tire wear. put these on and adjusted closer to spec and it definitely is not wearing the tires anymore.

Very impressed with quality & functionality of alignment cage.

Made alignment of the jeep so much easier and can do in my garage

Buyer/user beware....these are much cheaper than some of the competition....and for a reason. First, they work perfect. Dialed in the toe on my jeep to less than 1/16"....nearly perfect, first try. Fabulous product from this context. Only giving 3 stars because the edges are SHARP, specifically where you tighten the lug nuts...either run a stone over that edge or wear thick gloves. Your knuckles and fingers will thank you.

These are really nice! Thick stainless steel, and the tape measures are very nice too. All nicer than I had ever expected for being an inexpensive purchase. I used them on an '03 F350 Superduty 4wd. Measured my toe in/out before I replaced tie rod/draglink and reset it the exact same. Then I set my steering wheel exact center from that. It worked for me because of a solid front axle. These will be far less precise if you have any camber adjustability to do at the same time.

We needed to do an alignment on our side by side after hitting an underwater stump. These are the best tool for the job! It made it so easy to get it where it needed to be. They’re sturdy so they don’t bow or bend when using which definitely makes all the difference. The way the tape measures hook on to get the measurements correct is very functional and these are just easy to use!

A front-end alignment is only as good as the tools and the technician. I checked these angles for straightness and, they are plenty straight enough for using tape measures. May be about a .005" variance at the most. Set my 2020 Jeep Wrangler at 2mm toe in. Did the degree of angle calculation, came out to .205 degree. Right in the middle of the tolerance. Job done.