Lonffery 4 Pack Recessed D-Ring Tie Down Anchors (6,000 lb. Capacity), Heavy Duty Kit for Trailer or Deliveries, Black

When I need recessed D rings for my trailer these are my go to anchors. Very strong and solid design. The backing plate is thick. Very easy to install with a hole cutter. Thanks

This is a really good value. These tie downs are recessed so you're going to need a 3 1/2 inch hole saw to do this job going into 2 x 8 boards. Did not see this initially, got the saw the next day. The hardware seems very well made enough to secure a heavy riding lawnmower or a 550 pound motorcycle on a utility trailer. Installation is moderately difficult especially carving out the recessed holes in the board. Recommend a chisel to complete this task along with the saw. Completed looks very professional but haven't tried them out yet but overall very happy with these.

Sturdy and well made. Definitely going to order more.

as other reviewers noted the back plate holes do not seem to line up easily. I think the holes are 3/8" and I just drilled the back plate holes out to 7/16" and it worked perfectly. Once that was done it installed easily and looks great. Installed the recessed D ring on my aluminum trailer and it looks great and works perfectly for what I need.

This kit had everything I needed to install some great recessed deck tie down loops on my utility trailer. I liked that the backing plate was slightly offset. This allowed me to rotate it to fit against my frame. On another similar plate I got from the trailer retailer, the plate was centered…and I had to use an angle grinder to cut about 1/4” off that backing plate. This one was offset, so one side was closer to the edge. I put that edge near the frame, so the excess overhang was towards the inside of the trailer. The holes are NOT symmetrical, fyi. So doing that trick meant the eye loop folded laterally to the trailer. But that’s perfect for my application (center span tie town). The materials are good: galvanized steel and nylock nuts so they don’t rattle loose. Carriage bolts in a square hole, so one person can install them…even if you can only reach one side at a time (top or bottom). The hardest part was hogging out the wood so the recessed part would fit. The trailer guys said they just use a 3” hole saw and cut all the way thru. I am nervous to weaken the deck board by removing 50% of it. So, I only went down about 1” and used a router to hog out the cavity. And a little more by the bolt the eye loop rotates on to adjust the fit. Then drilled a 3/8” weeping hole all the way thru in the center for drainage. Put some copper stuff in there to avoid rot. That leaves 3/4” of wood thickness. This holds great on my other 4 similar tiedowns. First 4 I did with a hole saw and chisel. Next two I used a hole saw and router. I can’t say which was easier. Either way. These are great value and sturdy. I’d buy them again.

Top quality item.

I had two screws holding down the D-rings on my trailer break but otherwise the D-rings are holding up well.

Probably strong, but I'm returning these as I don't want to cut a 3" hole in my deck.

Anchors work very well and are used in a work trailer

Tout étais parfait

motorcycle tiedown

Exellent

I would have given 5 stars if it arrived with a template to cut into the trailer floor. And if it arrived with backing plates. Even a link to buy the backing plates would be helpful.