Weatherstrip Car Window Moulding Trim Sweep Felt Seal Kit Fit for Ford F150

I did a lot of research before pulling the trigger on these replacement seals for my 2007 Toyota Tundra and can assure you that these are the ones to buy. These seals fit perfectly, though I highly recommend buying an inexpensive set of car trim removal tools both to remove the original seals and insert the new ones. The flat-edged tool is essential in snapping the new seals into place by going along the inside pocket and applying pressure along the entire length to keep the seal from raising up. Start to finish this was a 15-minute job and the new seals look amazing. Packaging and overall quality of the product was top notch.

Perfect fit for my 08 FJ Cruiser. Installation was faster and easier than removing the factory pieces.

Lower door weather seal kit is junk. Does not fit super cab as shown in pictures. Clips are incorrectly made with cheap plastic and don't clip into factory holes. Avoid.

Really easy to install and looks great. Used on my 2011 Tundra. Took longer to take the originals off than it did to install the new ones. All I needed was a thick blade screwdriver inserted between the seal and the door to pop off one side of the old ones, then twisted as I pulled them up and off. New ones aligned perfectly. Would suggest using a folded washcloth and rubber mallet to get them to seat correctly, you will hear them click into place. Pretty simple. Took maybe 20 minutes total and didn't have to remove the door panel to do it.

Fits okay. The clippings weren't the best and can't hold. I was sent two driver side ones. I've already put on all 3 until the passenger side that I had notice it was not the correct one! Please contact me and send me the passage side. I will update reveiw if they contact me. UPDATE: customer service was A+ they contacted me and refunded me and I didn't even have to return the product. Will buy again from them for sure.

the back ones fit great. the front ones did not fit no matter how hard I pushed down they would not click in. replaced them with OEM, with little force the OEM front seals just clicked in. Honestly just bite the bullet and buy the OEM ones for the front at least.

Great off the box no bends on moulding

Fit perfectly. Easy to install

It's looks identical to the OEM part but if I install it on my FJ cruiser it just doesn't fit as an OEM part. Quality wise it's also completely different. OEM part lasted 8 years in dubai summers.

Ils étaient trop court…😐

Llegó a tiempo y se ajustó muy bien