Mcbazel 2 Pack Controller 3D Analog Joystick Thumb Sticks Replacement Repair Parts for Xbox One Elite 2

You really need to know what you are doing in order to do this job and have the right tools the value was good and everything functions like normal fit like oem seemed like good build quality Instructions: 1. Disassemble controller 2. I personally like to cut my none working joysticks apart and pull them out 1 by 1 like teeth it’s easier that way 3. Remove remaining solder I used flux and sucker with solder iron at 900F 4. Put new one in hold it down while putting new solder on I did 620F with little flux 6. The elite 2 remote self zeros so no need to manually do it 7. If you are doing elite 2 remote to test it put the two boards together and set it in bottom shell and plug it into pc/xbox to test it you can leave antenna wires disconnected this will help least likely to damaged it if you keep plugging and unplugging them higher risk of damage 8. After testing reassemble the remote and make sure the freakin buttons are in the proper way sometimes they shift and you will put the whole thing together and have to disassemble the whole controller again just to rotate a button 40 degrees Hope this helps NO tools or instructions were included

They work as they should and got completely rid of my drifting in my joysticks. They were easy to use and install on my own, the quality of them are 10/10 and the value for what you pay is a steal.

Gosh darn this was hard to install! That being said, they work as well as the factory ones on my Elite controller. This is much cheaper than a new controller if you get stick drift. That all being said, this isn't an install for beginners. The soldering involved is almost as hard as disassembling the controller. Being careful not to break anything or overheat the board it took about an hour to fix myself.

After the installation one of the sticks has drift. Very disappointing.

A bit better quality than the last ones I ordered from a different seller, and they work as intended.

Installed and worked perfectly

Buena calidad y precio, llegó rapido, muchas gracias.

Bought these to replace a stick that broke while taking apart the elite series 2 controller. Had no issues with install, doesn’t seem to be any drift on it, seems and feels as responsive as the original. Would recommend, but only if you have the soldering skills to remove and install the new one,

Repuesto prácticamente original, eso sí, pensaban que eran efecto hall, pero no

Per ora devi dire niente male , sostituiti entrambi e funzionano molto bene , vedremo con il tempo se terranno o anche loro saranno affetti da drift

I used these on my Xbox Series X/S 20th anniversary edition controller. Works just like on the Xbox Elite 2 controller. I did switch over the internals for one of the potentiometers. Make sure you have adequate tools and skill before attempting to fix your controller.

Works as expected

Cumplió expectativas