Pull Out Organizer for Bakeware, Cutting Board and Trays, 8.5"W x 21"D

This was well worth the price and, for aftermarket hardware, the price wasn't too bad. This was super easy to install. You will need a drill and I think it was a ⅛" drill bit (I used the next size down), & a Philips head screwdriver. Oh, and a bit of easy to remove tape to hold the template in place. It comes with a template and you simply fold the edge of the template over the lip of your cabinet and just make sure that the outline of the rails are where you want them positioned. There are little holes in the template that you place your drill bit on. I did actually use the next size down drill bit than what was recommended in the instructions. It worked great and the screw had more to bite into when I screwed it in. The recommended drill bit seemed too big, so I just changed it. After the holes were drilled I plucked out 5he template and just install the right and the left rails. It's pretty foolproof. The rails are labeled "right front" & "left front", so if you can't figure that out, please stop doing any DIYs, haha. Once the rails are screwed down (2 screws per rail) then you fully extend the rail arms and place the wire rack on it. Then slide it back. Done! The rack is super easy to put together too. It has 4 arched dividers that just pop into place. 2 need to be used on the far right and far left of the rack, but then you can space the middle 2 dividers however you choose. I chose to space mine evenly. I got this rack for my 12" base cabinet with a 9" opening. It fits perfectly. My base cabinet also has an upper drawer, but there is still plenty of space for my baking sheets and such to stand up.

SO easy to install. I did it myself without having to bug my husband. I was so proud of myself. It works beautifully. Smooth open and close. Adjustable dividers. My baking sheets are FINALLY easily accessible with the CF it was before. So very happy with this!

Easy to install and improved my upper cabinet functionality. It has a center handle so that I can easily pull it out to reach what I need. Slides smoothly. Adjustable spacing. I use mine for a variety of ceramic, wood, and metal trays/serving platters/pans.

EXCEPTIONAL quality and build for a GREAT price. Note this unit's dimensions and compare its functionality ! These pull out units are measured inconsistently .. a 13.8" unit might be 14" total width including the slide rails, excluding the slide rails, 14" exterior basket/tray width, 14" interior basket/tray width or it might be a general approximation that is close or not at all (one 14" unit we ordered was 12" tray and 12.75 overall ... for this unit the outside dimension of the basket/tray is 14" and the overall width with the slides is OVER 15". Another issue is how the basket/tray is attached to the slides - some are bottom mounted, some are side mounted and other are top mounted - meaning the bottom of the tray your item will sit upon can be anywhere from 3/8" above the cabinet shelf to over 2" above it so you need to take into account this height (which is often not provided and needs to be extrapolated form the images ... when selecting our cookie sheet unit "identical" pull out systems ended up requiring up to 3" additional height - that's significant in a cabinet that is only 20 to 22 inches tall to begin with. Then there is how the unit is attached to the slides - most units have a clip on the slide that the basket/tray drops into after the slide rails are installed - this is useful for installation clearances and being able to remove the basket/tray to clean under it once a year - others are screwed in or as in the case of this reviewed item - pre-rivetted and not removeable. Also some can accommodate a framed door where there might be a 1/4" to 1/2" lip around the opening. also consider the way the basket/tray will slide past or interact with the hinge mount - this can mean even if everything else fits great you might need a smaller width to that the basket/tray doesn't impact the hinge - which can result in wasted space next to the basket/tray inside the cabinet and a less useful width of basket/tray to place items in. Lastly is the gauge of the wire - this unit is very thin and lightweight - bordering on chintzy but since its a bread drawer its fine but some most are about a pencil in diameter but some are incredibly robust and heavy with a diameter of over 3/8" to 7/16" which is overkill unless you are loading the shelves with stand mixers, rocks, and gold bars - the puny 1/2" screws included or the cabinet shelf itself will give out long before the shelf does. Most importantly on a a unit like this with dividers to hold trays is the ability to make adjustments - this unit being reviewed is not adjustable once installed without having to remove it and unbolt it, then reassemble - total PIA. We returned it for that very reason - the one we kept had compression secured dividers that could quickly be moved 1/2" left or right to accommodate different trays without any other steps being taken. So review of this item: Quick Ship in an double wall unprotected medium wall cardboard carton wrapped in bubblewrap then plastic, medium weight and medium wire assembly (5/32") frame and 3/16" bottom grid. There is 10 3/4" available to set trays in 2, 3, or 4 divided compartments between the outer two sides - all are moveable in 1/2 inch increments and are held in place via expanded compression into slots and the base is REMOVEABLE from the slide rails (clips into four receiver clips, two on each of the slide rails with a 12 3/8" total unit width coming through the door opening and 12 3/4" required clear inside the cabinet, the tray is 3/4" above the shelf so you can slide a couple thin wire racks underneath it to maximize storage - see photos. The basket/tray bottom of the pull out that the cookie sheets sit atop is 2" above the cabinet shelf - so if you want to place a jelly roll pan that is 12" wide in the pull out the shelf above this unit would need to provide minimally 14' clear to accommodate the 12" wide plan sitting 2" above the cabinet. This unit can accommodate a framed door cabinet with a 1/4 - to 1/2" lip. The basket/tray can be removed form the slides to expedite installation or to allow for periodic cleaning underneath the basket/tray. The slide is a three part assembly offering full pull out without any perceptible bumps or stops at 1/3 or 2/3 points. The cut ends of the wire used for the basket/tray are smoothed. This is a 5 star item based on features, build quality, and details but at a very good price compared to others so if you need a high performing easily adjustable unit for under $45 compared to the $60-$100 options out there then this is a solid 6 star unit and really should be considered. The only draw backs (and this is typical with most not just this unit) are that it doesn't include a plastic or mesh bottom to prevent smaller items from falling through and the dividers do not have a back to them so it you pull the drawer out fast items can slide out the back end into the cabinet. I fixed this by zip tying an old flexible cutting board into the bottom and adding a 1" band across the back - see images. 100% satisfied with this item and I am hard to please and ordered 3 other styles to compare - this is as close to a perfect solution as can be and for under $50 - HIGHLY RECOMMENDED.

One less PITA in my life. If you're as frustrated as I was with baking sheets crashing to the floor trying to just pull one out - this pull out solves the problem. This was an easy install when I partially assembled the rails and tray to get precise locations for marking the screw placement. The template is close but not quite 100% on the mark. The pull out looks good and works perfectly - no more stuffing and shoving bakeware into the cabinet based on how the nest together. 4 of 5 stars due to a bent tab on one of the side rails - not bad enough to return, easy to fix. The order arrived a day early which was surprising since I'm in a semi-rural area.

This is a great purchase. It fits perfectly under the cabinet, pulls out flawlessly, holds a *crazy* amount of stuff and is very adjustable so you can put wider things in if needed. What can I say? I’ve got another one in my cart for the other side of the cabinet because it’s just so darn handy— even adjusts to hold my griddle neatly on its side. If you’ve been looking for a way to organize that disaster that is your cookie sheets, flat pans and cutting boards…trust me-this is it!

Instructions and installation were very easy. A paper template was provided so you can effortlessly align the pull out organizer within the cabinet as you please. You can cut the template down to align your organizer to the left or right-hand side if preferred. Screws were provided but you'll need a small drill and screwdriver to install. Super easy, however. The measurements provided include the rails. The slide out tray is approximately 7.25" wide. The wire "arms" are easily adjustable. This organizer is lightweight enough for me to use on the top shelf of my cabinet but still sturdy enough to properly house my baking sheets, etc. The gliding motion is smooth and overall construction is heavy duty and stable. I have bought several of these for my cabinets and love them. No more struggling with haphazardly stacked cookie sheets and muffin tins.

This rack is very sturdy. I placed to of them side by side and it works just fine. This versatile design allows for multiple sizes of pans. It's easy to use, it glides smoothly. I've been using this for at least a year and it is still as good as the day I installed it. Yes, me, not my husband!

Measure the depth of your cupboard to see if it will be deep enough. Easy to install and good quality. Works well.

This product is well made and it slides with ease and no noise. You can adjust the dividers for larger or smaller storage. This product was easy to install. love it

Superb quality and functionality, my wife loves it. She saw this on a kitchen renovation show on YouTube and wanted it as part of our own kitchen renovation. It's not cheap but well worth the cost. Super smooth bearings provide effortless movement both in and out. We highly recommend it!

This worked great in our cabinet. A real quality upgrade. It is very solid and quite easy to install!

Nice and sturdy, large pans can be placed and are well balance. An optional pull out handle would be appreciated for low to the floor applications where bending down low is required.