Cable Matters Shielded Cat6 Ethernet Cable for EtherCON RJ45, 50ft

This is a fine cable and works like it should. I use it in between 2 audio snake connectors. Now I just have to run one cable instead of a bunch! It is well made and flwxes nicely.

Good solid cable. It is a rather thick cable so the only issue I have with it is that it is hard to get it to lay flat at a gig. Hopefully it may gain a little more flex as I use it but I'll just have to see. The good thing is that this is a heavy cable and it appears that it will survive the gigging life (hundreds of wind/unwind, connect/disconnect cycles as well as being walked on!) for quite some time.

Well built! Will work as well as more expensive bigger names! EtherCON cables are quite large in diameter. Be aware of this if you've not used them before. The outer jacket on this cable was soft and pliable, however, making it just as good as much more expensive cables.

Used this for an uplink from my SQ7 to an AR2412 stagebox. Works perfectly but I worry with how stiff the cable is, if it will last long. Only time will tell but it has high quality metal connectors, not Neutrik by any means but still not junk. Works for pretty much anything that requires shielded cat6 and will work for anything that requires cat5e I’ve bought a lot of cable matters stuff in the past and they never seem to let me down

This has been a very nice cable and has held up well for my X32 rack and S16 stage box. It's pretty stiff, so I run it along the floor and then up to my devices. I'd recommend this cable to anyone.

Mis 40 Metros de cable y yo somos felices desde que los compre.

Works great

I purchased two different brands of EtherCON cables, and they are basically the same, with a shielded cable underneath an extra jacket. Seems like it makes the cables extra resistant to damage, but it also makes them a bit unwieldy. Still, it is a quality cable, and I recommend it if you're planning to use EtherCON in your audio setup like we are. I'm using two of these cables and four 4-way boxes to replace one analog snake. The benefit is that I can run them to two different areas on the stage instead of one 8-way snake sitting in the middle.

Do not buy. Low quality conductor in the cable! I haven opened it, but I assume it’s copper coated aluminium rather than real copper conductors.

El material es resistente y de muy buena calidad

I purchased this on a whim, as i wanted a backup cable for my JTV59 Variax guitar. Line6 no longer sell or stock their Variax cables, I tried multiple Guitar stores with no success. The only other way I was told I could get one was to buy an new/old stock Variax guitar (that's if you can still find one). So i purchased this ethercon cable through Amazon to try it out and it works great! If you have a Variax guitar and your Line6 cable no longer works etc, this does the job. Its a bit stiffer than the Line6 cable, but works just as well.

Parecen cables de baja calidad en su recubrimiento plástico.