Arisaka Optic Leveler Combo – Precision Mounting Tool for Scopes OL-Combo

One of those items that I'll rarely use but glad I purchased. Precision made and does the job perfectly. One tip - don't apply too much pressure as you tighten the rings otherwise they can get stuck between the scope body and the rail.

This site alignment tool is great! It makes setting up a scope a lot easier. Very simple to use too.

This is my go-to for mounting scopes. It has not let me down, and a few of my friends asked me to borrow it.

Much easier to level out scopes

Great system I just suck at leveling lpvos , worth the investment and super easy to use, I couldn’t get my optic lines up but I’m pretty sure it’s the optic not the leveler

This is a quality product. There are cheaper imitations. I spent about 2-grand on the rifle and optics. Why cheap out on mounting the scope?

these work great and they are super fast if you need to lever your scope

Like other posters have said, so simple yet it is ridiculously effective. I had been having issues leveling a long range rifle scope. I just could not get it exactly perfect. Saw these on Amazon and gave them a try and I am a believer now for sure. Verified with a pendulum, the crosshairs are dead on perfect. Simple to use: Loosen your scope rings up just a little so you can turn the scope with some effort, but so it is not sliding around. Slide the little flat piece with the cut in it onto your rail or flat spot on your mount. It fits perfectly on a picatinny rail. Slide whichever angle piece (writing side up/readable) into the cut on the flat piece so it is on the flat bottom piece of your scope at the knobs area. Work it back and forth and move the scope back and forth til it seats tight and you can't see any daylight - check both side to verify it is tight. Tighten your scope back down with the unit still in place, holding the scope level and work it out as you are tightening. Tada - level scope! Now note there are some limitations here you should be aware of. 1.) Clearance between your scope and mount/rail. The scope I was mounting had a ton of clearance between the scope and mount and I used the system easily. Another rifle I have, there is not enough space to even get the flat part in between the scope and rail. Something to pay attention to. If the bottom if your scope is millimeters off the top of your route, this may not work for you. 2.) It's not me, it's you! - Your scope could be an issue. If it is a scope of lesser quality or a scope that has a defect in it, you might level the scope with this unit and have it be totally flat but when looking through your scope, the crosshairs are canted. That would be a manufacturing issue with the scope and you will have to use a pendulum or eyeball it instead so the crosshairs are truly aligned based on what you see through the scope. If you are using any of the big scope players like Leupold, Vortex, Nightforce, etc. you should be fine.

Easy to use and a quality product

A good product that helps with quick field setups. make sure your windage and paralax turrets aren't bigger than the base of the scope, they will interfere with this set up tool. Very similar to my Spuhr tool.

Works awesome used it today