nextzett Klima Cleaner Pro – Automotive AC Odor Eliminator & Evaporator Cleaner – Freshens & Cleans Air Conditioning System – 10 fl oz (12 Pack)

This product did exactly what it was advertised to do and it eliminated the bad odor. The instructions were easy and I will purchase again for my next filter change. Recommend this product for use.

This product works! It took only once and it worked on my GMC Terrain. I had a musty smell when the AC was on but this resolved the issue. I do wish the included straw was about 12" longer... It took me two tries because I didn't realize the bottle needed to be kept upright to expel the cleaner properly. Once I repositioned the can so it was upright and pressed the button I was able to get it all out, but I think it would have done better if I did that the first time.

I bought both the nextzett Klima-Cleaner and the Lubegard Kool-It. The spray nozzles nozzles are actually interchangeable. The Kool-it just has a straight nozzle, whereas the Klima-Cleaner has a tri-pattern nozzle that spreads its out. I would say the spread nozzle would work if you went through the drain tube, but I preferred the straight nozzle for going through the blower fan area. You could just cut the spread nozzle, and crimp it a bit for the same results. For sure, the Klima is a better value. It says 6 oz vs 10 oz, but that is clearly not true. The Kool-it shot for like 6 seconds and the can was empty. The Klima just kept going and going. I must have filled the evaporator chamber like 4-5 times. One caveat, make sure the spray tube is ALL THE WAY inserted into the white cap. ALL THE WAY. Otherwise, it has the habit of blowing off randomly. After using both and draining, I ran the fan with the windows open for a few minutes, then the AC. It was blowing clean, cold air. No more faint mildew smells. The rest of this is vehicle specific. Kia Sportage 2018. 1. Open the glove compartment. There is a clip on the outside, right side. Squeeze the clip and slid off. There are 2 knobs inside, left and right. Rotate CCW and remove. The glove compartment should drop. 2. There are still two pins holding the glove compartment. Squeeze the end of the pin to free and pull out. You will need to support the glove compartment to make it easier to pull the pin. 3. The cabin air filter has a cover. Squeeze the clip on the left side and slide out. Remove the cabin air filter. 4. There is an undercover for the blower fan. Two recessed clips near the front you can carefully feel. Pull them toward you and you can pry down the cover. Requires a bit of strong fingers for these clips. After you free the front of the cover, there are two foam covered tabs in the back you can wiggle out. 5. You can remove the blower fan with 3 philips screws. The fan plug will require pliers to squeeze the tab for removal as it is very tight. 6. The blower fan was blocked by a plastic housing in the front. I removed a screw in the front, and the housing loosened enough to free the blower. 7. I taped an endoscope to the spray tube, placed down a flashlight inside the blower housing facing left, and with a laptop, I was able to see inside clearly. If I was to redo, I would 3D print a holder to make the tube+endoscope more rigid so I could see deeper in and easier. Possibly also make it a right angle spray to hit the coils directly. I was able to liberally coat everything I could see, and thoroughly fill that compartment. Then wait for the foam to liquidize and repeat. I did not worry about the blower resistor as from what I can see with the endoscope, it was well protected with its position.

Worked pretty well. Flexible hose means you can actually get it up inside a condensate drain without having to drop your motor. Leaves behind a pleasant but not overpowering odor.

This cleared up my musty air in our Lexus rx350. The hardest part was finding the best way to inteocude the spray. I ended up taking a panel off under the dash and found the drain tube.

Included spray tube and the replacement cap to connect tube worked great. Others have commented that the tube doesn't fit the spray cap. You need to pull off the cap that comes attached to the can and press on the included replacement cap. Pull off firmly, you wont break anything. The tube fit securely on the replacement cap stem. This can has more foam in it than other brands suggested in numerous youtube videos. Be sure to shake can vigorously, or else all that will come out is fluid. I think that this cleaner did more to clean out the AC condenser coil ducting/drain system, than it did to clean the actual coil. My coil was super clean to start with, but there was a mildewy smell for about 2 seconds when the AC was first turned on in my car (after humid conditions). I think the smell was from stagnant water in the condensation drain ducting, not mold on the actual coil. The foam dripped out of the drain as expected, so the drain wasn't clogged. Tesla cars are programmed to run the fan for 10-20 minutes after parking to dry out the AC condenser coil and ducting, but if you open the door again after getting out, the fan is interrupted and does not restart. That's my observation. This could change in future over the air software updates. A month later, the smell has NOT returned, so I am a happy customer. Would use yearly, if smell were to come back next spring. I am betting that it wont, due to the fan update from Tesla.

Great product and the foam will keep your ac system smelling very nice and clean. And of course cold

جيد

I recently used the Nextzett 96110515 Klima-Cleaner Air Conditioner Cleaner on a Tesla Model Y, and it has proven to be an excellent choice for maintaining the air conditioning system. This cleaner excels at thoroughly cleaning and disinfecting the internal components of the air conditioner, significantly enhancing both performance and air quality. I used the entire can in two applications. It is important to ensure that the foam completely filled the enclosure and reaches every corner of the evaporator coils. After approximately 20 minutes, the foam transformed into a liquid, resembling water, and safely dripped out from beneath the car. Before reinstalling the filters, I ran the fan for an additional 20 minutes to ensure the compartment was completely dry, preventing the filters from getting wet. One of the standout features of the Nextzett Klima-Cleaner is its ease of use. The product comes in a convenient spray bottle and includes a tube, which is essential for applying it directly to the evaporator coils and other accessible parts of the air conditioning unit. The foaming action of the cleaner effectively breaks down and removes dirt, grime, and mold buildup that can accumulate over time. This not only boosts the efficiency of the air conditioner but also helps to extend its lifespan, provides a fresh, clean odor, and improves airflow by clearing any obstructions. Overall, the Nextzett Klima-Cleaner Air Conditioner Cleaner is a reliable and effective solution for anyone looking to maintain their air conditioning system. It offers a straightforward and efficient way to keep your unit clean, enhance air quality, and ensure optimal performance.

This product is easy to use and it does what it says on the tin. Gets rid of nasty smelly air con smells.

Efficace mais difficile d'appliqué correctement. La mauvaise odeur est chose du passé. Pour revenir sur les instructions, pour être efficace il faut absolument que le produit soit appliqué sur l'évaporateur. Deux façons soit par les bouches centrales d'aération soit par l'entrée d'air après le filtre de cabine. J'ai appliqué des deux manières. Toutefois dans chacune des solutions, il faut bien vous assurer d'atteindre l'évaporateur sur toute sa surface chose demandant beaucoup de patience et de dextérité. Dans mon cas, j'ai utilisé un caméra pour m'assurer de bien diriger le produit. J'ai utilisé le produit auparavant sans voir ce que je faisais et les résultats étaient beaucoup moins bons. Cette fois je peux confirmer que le produits est très efficace. Aucune senteur depuis l'application. Par les bouches d'aération, dans mon cas il y a tellement d'obstacles que la probabilité de bien nettoyer est pratiquement nul. On nettoie simplement le conduit d'air et non l'évaporateur sauf un infime partie celle où passe le liquide évacué. Je recommande ce produit aux bricoleurs équipés d'une caméra.