Cordinate 6ft Floor Cord Cover, Cable Protector, Hide Extension Cords

Purchased this to put husbands oxygen tube through where it comes from the concentrator and lays across the floor so that he is not tripping over tubing in the middle of the night. Perfect for our safety and does what needs to be done. Make sure you use a blow dryer to get it to lay flat as it comes curled up and takes awhile to straighten itself out. Adhesive won't work as well on carpet until flat.

Worked great to cover the cord, but the sticky on the back doesn’t stick well on the ends, was easy to set up, perfect length, blends in well and protects the cord,

Purchased to cover a cord running from the wall to our couch that was a major tripping hassle (the only entryway we have). We needed the cord so we could plug in electronics (lamp, chargers, etc). The cord cover is heavy and stays in place. We were able to easily trim the length to make it to fit the space. No one has tripped or fallen since installing. It stays in place amazingly well and matches the color of our carpet well enough to not stand out. Purchased in 2021 and have zero complaints! Would absolutely purchase again!

Needed to run some ethernet cables, didn't want to start cutting holes in things. These cable runs let me cross a high-traffic space without problems. They are fairly thick, but pretty sturdy, too. My one gripe is that they come rolled up, and it is hard to get them to really flatten out. (They come with tape to secure them to the floor, but I don't want to use that while crossing carpet. A good product, that I would buy again if I needed it.

First of all, the item itself looks fine visually when on the floor, you get what you see. However I had 2 big problems that hinder how helpful it is around the house. First big issue I have is the gap below for you to put your cords in is way to wide. Due to how wide it is, the cords easily slip out constantly even when using the adhesive. It would be better to make it easy to pull open, but have it fully close to keep the cords in it. This gap also has a negative effect on the adhesive itself. The adhesive has a much smaller width than the slot you place the cords in. Because of this I am unable to really place the adhesive on the product really well to where I don't either have it disconnecting from the cover, or have the cords sliding out. This would not be a big issue if they gave you more so perhaps you could put it on both sides, but it is only enough for you to tape it straight down the middle.

We bought this a while ago I wanted to wait to do a review we put it over our projector cords in a high traffic area in our basement and it has stopped so much tripping and goes almost seamlessly with the basement floor very durable took a little while to get it flatted out but is a great product!

I bought this cord cover because I have a cord running through my room and wanted to cover it. So I bought this. Not a bad product, maybe it is because I have older parquet tiles on my floor, but the product kept letting cat litter under it, making the room harder to clean. When I pulled up the cord cover, it left adhesive on my floor. Not a product I would buy again and feel it was a waste of money. It is not the product's fault. Maybe it's mine or my older floor tiles. Who knows.

Great product that works as advertised - once you get it to uncurl and lie flat on the floor. Taking a cue from a review of a similar product, I soaked the entire (very tightly curled) product in a sink full of HOT water (the hottest I could get out of the sink), making sure the entire thing was covered by water. After about 5 minutes of soaking, I pulled it out - and it was extremely soft and flexible. I dried off most of the water and then laid the product on a towel on the floor, laid another towel on top of it - and then covered the length of the entire product with stacks of books to ensure it got fully flattened out. An hour or so later, I uncovered everything - and it was totally flat (and firm) once again. A little bit of a hassle - but it works like a charm to make it flat as a pancake.

El protector es de tamaño adecuado. Cómo viene enrollado toma tiempo quedarse plano, yo lo solucione con una secadora de cabello

Prevents a trip hazard

I have some cables running across walk ways (e.g., ethernet), and other attempts to stick them down (e.g., tape) were sabotaged by my robot vacuum or proved ineffective at preventing trips by guests. I don't like running cables along roofs - I think its an even worse eyesore than running them across the floor (and its a rental so I'm not drilling holes). Although its expensive (I believe I paid ~$25 for 2 metres, therefore ~$12.5/metre), it was enough for my needs. The double-sided tape has done very well. Some people still trip on it occasionally, although the trips are far less dramatic compared to when a cable would snag your foot, so its a great improvement there. Robot vacuum glides over with ease. It arrived rolled up, but luckily my housemate has a heatgun when i used on a low setting to gently straighten it out. You could do the same with a hair dryer, or leaving it in the sun (maybe). Cutting to size was relatively easy with both a stanley knife and/or robust scissors - but be careful, some force was required and there is a risk of the blade slipping and you cutting yourself, so scissors would be safer. Overall, if you're willing to pay, this will do the trick. Maybe shop around first or wait till its on sale (and in the mean time, duct tape would do the trick).

Fácil manejo, buena calidad.

I saw complaints about the cord cover being hard to straighten. I wrapped it in a dry towel and put it in a dryer for 20 minutes. Heat makes it easy to work with, you can just lay it on the floor and it'll stay straight. Just let it cool. It came with a single roll of tape but I haven't used it yet so I don't have any comments about it.