Jinyi 87-88107A8 87-88107A5 Boat Ignition Key Switch for Mercury Outboard Remote Control Box, 3 Position 6 Wire Push-to-Choke Marine Starter Switch, Fits Mercury 1994 & Up Motors 30-300HP

Replaced an ignition switch on a Tracker Pro 160 boat. Worked perfectly. Not hard to install. Quality was good. I found it a bit hard to get housing tightened so that body did not spin, but got there.

very universal and easy to wire up

Purchased this for a 2005 Mercury Salt Water series 150hp and this replaced the OEM switch perfectly. Wires are all the same, dimensions are really close but the diameter of this switch is slightly larger. I had to modify my bracket a smidge to get it to fit but it was really easy to do and didn't take much effort. After installing, cranked right up and the automatic electric choke worked as well. And it was half the price of the actually mercury OEM part, so that was nice to save a few bucks, because as we all know, boats are just a hole in the water that you dump money into.

The ignition switch on my Basstracker TX-175 started acting strange and eventually got to where it was questionable if it would start the boat. Replaced it with this one and problem solved. Installation was pretty straight forward, wiring colors all matched the factory. For a good installation solder the wires and cover them with a good marine grade sealing connector. Installation took about an hour. Pulled the old ignition out of the boat by unplugging the connector. Soldered new switch to that connector and plugged it back in. Works great.

I'd never replaced an ignition switch, and when I observed the amount of wires landing on it, I debated taking it to a boat mechanic. The wires were all color coordinated and easy to match up - which was a concern for the age of my motor. Everything worked perfectly. Only advice would be to use small, silicone water "proof" wire nuts in lieu of the shrink style butt connectors. I purchased 3 different crimping pliers, and none would grip the wire to my satisfaction. The length of the switch was a little long, but with some force everything fit.

Fit out 2005 pontoon perfect. All wire colors matched our boat....i checked with a multimeter just to be sure.

Wires color coded for easy, correct replacement. Well made with epoxy filled and sealed wires to make water proof and provide strain relief on wires exiting switch body. As others have mentioned, needed to very slightly reem out hole as this is just too tight to force through old pass through hole. Also, about a thick 1/4" longer than my old switch but I did have enough clearance. Works perfect. 225hp Merc turns over and starts better than ever. Nice price and quality product.

The housing is just a little bit too long to fit in my 1999 Force outboard controls. I was able to take a pair of side cutters and trim excess plastic from the back and get it to fit. Once I got it installed everything seemed to be fine until I cranked the engine and the key fell out of the switch. At this point I just use the key to crank the engine then put the key in my pocket until I need to turn off the engine. The switch was very inexpensive though I just wish the key would stay in.

It was exactly as it was listed. Arrived 2 days early. Was very happy

Cet article N'était pas compatible avec mon bateau.