4 string Bass Bridge Hard Tail Fixed Top-Load or String-thru Body

The two holes at the top of the bridge line up perfect with the old Squier Bronco bridge. You will have to drill holes at the bottom but all you need is an electric drill and you’re good to go. It wasn’t too difficult, just start drilling slow. One user said they had to scratch the back plate for conductivity, I found this not to be true. I restrung and tested it and everything was great. Great bridge for a project bass or upgrade for the Bronco with the old two saddle.

So if you’re looking at my review then you’ve probably been on the hunt for a bridge replacement for a Squire Bronco bass, and it’s been a tough search. Good news! This absolutely works. The Bronco’s standard string spacing is 17mm, and most people say that 17mm or 18mm will work but 19mm won’t. This bridge is 19mm, but I took a gamble on it. It absolutely worked! There’s plenty of room on the fretboard for it and it caused zero issues. So, I believe, and 19mm will be the same. Also, the top two screws (closest to the pickup) are in the exact same position as the Bronco’s stock bridge. I just but the bridge in the exact same spot using those two holes and it’s perfect. Even the intonation was on. So, this bridge absolutely works for a Bronco Bass!

I replaced the bridge on my GLarry bass because the original would not go high enough. This one fixed my problem.

Fits perfectly in my cheap but lovely Sawtooth EP 4 string bass. Had a stock bridge that was lame for intonation and this one does a good job. Can't complain for the price and surprised for the quality. If you have a Squier Affinity or similar it's a MUST GO. Would buy again and recommend. Keep in mind it has 7 mounting screws, 5 on the back and 2 on the front.

YAY!!!!!! IT FITS. THANKS

I used this bridge to modify a Squier Bronco Bass. The stock bridge on the bronco only had two saddles, so regardless of the adjustments on the stock bridge, as result it suffered from some serious intonation problems as you climbed the fretboard. I was looking for a cheap replacement and this fit the bill. Minimal drilling, string spacing worked, and all in all it was fine. Note of caution, the bridge is designed to fit a Jazz or P Bass style, so on the short scale Bronco, I had to adjust the saddles to their limits to get the strings intonated, but it worked, looks good and has held up well so far.

A good and cheap replacement for an old cheap bass. Does its job and no need for an upgrade. Had to drill in new holes to fit the screws since I couldn’t find the right part for my cheap old 80s-90s bass.

Worked great intonated very well and easily The only downside was the coating is not conductive Had to scrape a section off the back to properly connect the ground wire. Outside of that it's perfect

I bought this black bridge for a blacked out bass I was building. The bridge works well and the screw holes line up. I didn’t like that the screws were not the same length as the fender bridge but I still worked out. And for some reason this bridge has 2 extra screw holes in the front…i chose not to drill and let it as is. Over all it works and did what i wanted ✌🏼

Fits my Fender bass persision perfectly.

Excelente producto ya te viene con una llave para ajustar el puente, me sirvio para remplazar mi viejo puente de mi bajo