12V-24V Flash Strobe Controller Flasher Module for 3rd LED Brake Lamp Tail Stop Lamp (Pack of 4)

I’ve only wired on of them to my Trunk brake light on Kawasaki Voyager 1700 and it works great and I noticed people are stopping further behind me at traffic lights. Great Investment!!!!

this makes your rear topper brake light flash, its all about being seen on the road, its easy to install , works like it should, you could use it on any 12 volt system. the sale was good, no problems....

😊 I recently installed the BlyilyB 12V-24V Flash Strobe Controller Flasher Module in my 2008 Chevy Tahoe, and it's been a fantastic upgrade! 🚙💡 The module allows my 3rd LED brake light to flash three times rapidly when I apply the brakes, then stay on steady, significantly enhancing visibility and safety. 🚨 The installation was straightforward—just connect the module between the brake light and the vehicle's wiring, and you're good to go. 🔧 The module is compatible with 12V to 24V systems, making it versatile for various vehicles. ⚙️ Since installing it, I've noticed increased attention from other drivers when I brake, especially in heavy traffic. 🛣️ It's a simple modification that makes a noticeable difference in safety. ✅ If you're looking to enhance your vehicle's brake light visibility, I highly recommend the BlyilyB Flash Strobe Controller. It's an affordable and effective solution! 💯

Well, they work great and are easy to install... once to figure out that it is wired completely backwards. After installing one, thinking it was defective, installing a second one and finding it didn't work too, did I consider that the directions were wrong. The product wiring is labeled "in" and "out". After considering that they were backwards, I wired it with the "out" as the in and the "in" as the out, it worked fine.

Perfect for my third brake light

These are great, very functional light flashers for safety! I put all new led's on my motorcycle trailer & installed one of these modules on the brake lights. If they say they can't see me now, they need to have there keys taken away! I love that they sort of flash randomly & quick to start, then a couple of slow flashes, then solid so it will get attention from other drivers!

Not a single one of the four worked. I carefully first connected 'tm 'em to a small battery -- a battery that illuminated my LED when these 'flashers were absent from the circuit. But when I connected each of them carefully following instructions, none of 'em worked. In fact one of 'em just lit the LED continuously. None of the rest of 'em did anything. Even at $2.75, they are not worth the price.

These are great. Installed on my 03 Miata NB. People are always pulling up far too close behind me as if it's OK to crowd the little car. This has helped a lot to cut down on that.